Electrical buses are going in !

My very own Tower of Hanoi – spools of 18G Automotive wire.

And now one side is done. At this point DCC and DC are both distributed along the back end of the bench work and there are feeds to each slide out panel.

You will notice I am crimping spade terminals, if you want to see the proper crimping method (yes there a right way to do this !) watch this video.
If you want part numbers here they are :
Terminal strips along frame: CONN BARRIER STRIP 6CIRC 0.437″,¬†¬†Terminal Strips on Slide out panels : CONN BARRIER STRIP 6CIRC 0.374″.

Leave a Reply

Your email address will not be published. Required fields are marked *